Denso BHT-1505B - 5.3.2 Communication via MTP Connection

189
Barcode Handy Terminal
5.3.2 Communication via MTP Connection
1. Set the USB connection mode of the BHT to the MTP. Refer to Chapter 4.5.12 “USB
Communication Settings” for details.
2. Set the MTP communication protocol options of the BHT. Refer to Chapter 4.5.12 “USB
Communication Settings” for details.
3. Connect the BHT to the host computer with the USB cable.
4. The BHT is acknowledged as a portable device (the device name is “Handy Terminal”) and you
are allowed to operate files on Windows Explorer.
The MTP can be used while the application is running or in the
SYSTEM menu, DOWNLOAD menu and UPLOAD menu. Proceed to
the DOWNLOAD menu or UPLOAD menu to start the MTP
communication.
━
Note
━

Use the host computer that runs on Windows XP SP2 or later and is installed with
Windows Media
Player ver.11 or later.

If the BHT is acknowledged
as an imaging device, start the Windows device manager, delete
“Handy Terminal” and then connect or disconnect the USB cable.
━ Po in t ━

Communication may not be established depending on connection destination or the cable.

Connect the USB cable directly to the USB port on the host computer.

Communication may be degraded or interrupted if the BHT is connected via a hub.

Do not plug in and
out the USB cable repeatedly in a short cycle. The host computer may be
locked.