Digi Connect IT 16 User Manual

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 16/48 User Guide
111
(config network interface my_wwan)> ipv4 mgmt num
(config network interface my_wwan)>
e. Set the MTU:
(config network interface my_wwan)> ipv4 mtu num
(config network interface my_wwan)>
f. See Configure SureLink active recovery to detect WAN/WWAN failures for information
about configuring active recovery.
10. Optional IPv6 configuration items:
a. Click IPv6 to expand.
b. IPv6 support is enabled by default. To disable:
(config network interface my_wwan)> ipv6 enable false
(config network interface my_wwan)>
c. Set the metric.
(config network interface my_wwan)> ipv6 metric num
(config network interface my_wwan)>
See Configure WAN/WWAN priority and default route metrics for further information about
metrics.
d. Set the relative weight for default routes associated with this interface. For multiple active
interfaces with the same metric, the weight is used to load balance traffic to the
interfaces.
(config network interface my_wwan)> ipv6 weight num
(config network interface my_wwan)>
e. Set the management priority. This determines which interface will have priority for central
management activity. The interface with the highest number will be used.
(config network interface my_wwan)> ipv6 mgmt num
(config network interface my_wwan)>
f. Set the MTU.
(config network interface my_wwan)> ipv6 mtu num
(config network interface my_wwan)>
g. See Configure SureLink active recovery to detect WAN/WWAN failures for information
about configuring active recovery.
1. Save the configuration and apply the change:
(config)> save
Configuration saved.
>

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English