Digi Connect IT 16 User Manual

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 16/48 User Guide
110
where value is one of:
n none: The device will perform no alternative action if automatic SIM switching
is unavailable.
n reset: The device will reset the modem if automatic SIM switching is
unavailable.
n reboot: The device will reboot if automatic SIM switching is unavailable.
7. The Connect IT 16/48 device uses a preconfigured list of Access Point Names (APNs) when
attempting to connect to a cellular carrier for the first time. After the device has successfully
connected, it will remember the correct APN. As a result, it is generally not necessary to
configure APNs. See Configure cellular modem APNs for further information and instructions
for setting an APN.
8. (Optional) To configure the IP address of a custom gateway or a custom netmask:
a. Enable the custom gateway:
(config network interface my_wwan)> modem custom_gw enable true
(config network interface my_wwan)>
b. Set the IP address and netmask of the custom gateway:
(config network interface my_wwan)> modem custom_gw gateway ip_
address/netmask
(config network interface my_wwan)> modem custom_gw
To override only the gateway netmask, but not the gateway IP address, use all zeros for
the IP address. For example, 0.0.0.0./32 will use the network-provided gateway, but with
a /32 netmask.
9. Optional IPv4 configuration items:
a. IPv4 support is enabled by default. To disable:
(config network interface my_wwan)> ipv4 enable false
(config network interface my_wwan)>
b. Set the metric:
(config network interface my_wwan)> ipv4 metric num
(config network interface my_wwan)>
See Configure WAN/WWAN priority and default route metrics for further information about
metrics.
c. Set the relative weight for default routes associated with this interface. For multiple active
interfaces with the same metric, the weight is used to load balance traffic to the
interfaces.
(config network interface my_wwan)> ipv4 weight num
(config network interface my_wwan)>
d. Set the management priority. This determines which interface will have priority for central
management activity. The interface with the highest number will be used.

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English