Interfaces Wide Area Networks (WANs)
Digi Connect IT® 16/48 User Guide
79
where value is one of the following:
n main
n aux
n both
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure cellular modem APNs
The Connect IT 16/48 device uses a preconfigured list of Access Point Names (APNs) when attempting
to connect to a cellular carrier for the first time. After the device has successfully connected, it will
remember the correct APN. As a result, it is generally not necessary to configure APNs. However, you
can configure the system to use a specified APN.
To configure the APN:
WebUI
1. Log into the Connect IT 16/48 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. For APN, type the Access Point Name (APN) to be used when connecting to the cellular carrier.
4. (Optional) IP version:
For IP version, select one of the following:
n Automatic: Requests both IPv4 and IPv6 address.
n IPv4: Requests only an IPv4 address.
n IPv6: Requests only an IPv6 address.
To Next Page
Loading...
Need help?
General