Digi Connect IT 16 User Manual

Routing IP routing
Digi Connect IT® 16/48 User Guide
198
b. Set the zone. For example:
(config network route policy 0)> src zone external
(config network route policy 0)>
See Firewall configuration for more information about firewall zones.
n interface: Matches the source IP address to the selected interface's network address.
Set the interface:
a. Use the ? to determine available interfaces:
(config network route policy 0)>src interface ?
Interface: The network interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
/network/interface/sfp1
/network/interface/sfp2
/network/interface/wwan
Current value:
(config network route policy 0)> src interface
b. Set the interface. For example:
(config network route policy 0)> src interface
/network/interface/eth1
(config network route policy 0)>
n address: Matches the source IPv4 address to the specified IP address or network. Set
the address that will be matched:
(config network route policy 0)> src address value
(config network route policy 0)>
where value uses the format IPv4_address[/netmask], or any to match any IPv4
address.
n address6: Matches the source IPv6 address to the specified IP address or network. Set
the address that will be matched:
(config network route policy 0)> src address6 value
(config network route policy 0)>
where value uses the format IPv6_address[/prefix_length], or any to match any IPv6
address.
n mac: Matches the source MAC address to the specified MAC address. Set the MAC
address to be matched:

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English