Services Location information
Digi Connect IT® 16/48 User Guide
385
d. Click again to add an additional point, and continue adding points to create the
desired polygon.
For example, to configure a square polygon around the Digi headquarters, configure a
polygon with four points:
This defines a square-shaped polygon equivalent to the following:
7. Define actions to be taken when the device's location triggers a geofence event:
n To define actions that will be taken when the device enters the geofence, or is inside
the geofence when it boots:
a. Click to expand On entry.
b. (Optional) Enable Bootup action to configure the device to perform the On entry
actions if the device is inside the geofence when it boots.
c. For Number of intervals, type or select the number of Update Intervals that must
take place prior to performing the On entry actions.
For example, if the Update interval is 1m (one minute) and the Number of
intervals is 3, the On entry actions will not be performed until the device has been
inside the geofence for three minutes.
To Next Page
Loading...
Need help?
General