Services Location information
Digi Connect IT® 16/48 User Guide
386
d. Click to expand Actions.
e. Click to create a new action.
f. For Action type, select either:
l Factory erase to erase the device configuration when the action is triggered.
l Custom script to execute a custom script when the action is triggered.
If Custom script is selected:
i. Click to expand Custom script.
ii. For Commands, type the script that will be executed when the action is
triggered. If the script begins with #!, then the proceeding file path will be used
to invoke the script interpreter. If not, then the default shell will be used.
iii. Enable Log script output to log the output of the script to the system log.
iv. Enable Log script errors to log errors from the script to the system log.
v. (Optional) For Maximum memory, type the maximum amount of system
memory that will be available for the script and it spawned processes.
Allowed values are any integer followed by one of the following:
b|bytes|KB|k|MB|M|GB|G|TB|T.
For example. the allocate one megabyte of memory to the script and its
spawned processes, type 1MB or 1M.
vi. Sandbox is enabled by default. This prevents the script from adversely
affecting the system. If you disable Sandbox, the script may render the system
unusable.
vii. Repeat for any additional actions.
n To define actions that will be taken when the device exits the geofence, or is outside
the geofence when it boots:
a. Click to expand On exit.
b. (Optional) Enable Bootup action to configure the device to perform the On exit
actions if the device is inside the geofence when it boots.
c. For Number of intervals, type or select the number of Update Intervals that must
take place prior to performing the On exit actions.
For example, if the Update interval is 1m (one minute) and the Number of
intervals is 3, the On entry actions will not be performed until the device has been
inside the geofence for three minutes.
d. Click to expand Actions.
To Next Page
Loading...
Need help?
General