Services Location information
Digi Connect IT® 16/48 User Guide
387
e. Click to create a new action.
f. For Action type, select either:
l Factory erase to erase the device configuration when the action is triggered.
l Custom script to execute a custom script when the action is triggered.
If Custom script is selected:
i. Click to expand Custom script.
ii. For Commands, type the script that will be executed when the action is
triggered. If the script begins with #!, then the proceeding file path will be used
to invoke the script interpreter. If not, then the default shell will be used.
iii. Enable Log script output to log the output of the script to the system log.
iv. Enable Log script errors to log errors from the script to the system log.
v. (Optional) For Maximum memory, type the maximum amount of system
memory that will be available for the script and it spawned processes.
Allowed values are any integer followed by one of the following:
b|bytes|KB|k|MB|M|GB|G|TB|T.
For example. the allocate one megabyte of memory to the script and its
spawned processes, type 1MB or 1M.
vi. Sandbox is enabled by default. This prevents the script from adversely
affecting the system. If you disable Sandbox, the script may render the system
unusable.
vii. Repeat for any additional actions.
8. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT 16/48 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
To Next Page
Loading...
Need help?
General