User authentication Authentication groups
Digi Connect IT® 16/48 User Guide
501
1. Log into the Connect IT 16/48 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Groups.
4. For Add, type a name for the group and click .
The group configuration window is displayed.
5. Click the following options, as appropriate, to enable or disable access rights for each:
n Admin access
For groups assigned Admin access, you can also determine whether the Access level
should be Full access or Read-only access.
where value is either:
l Full access full: provides users of this group with the ability to manage the Connect
IT 16/48 device by using the WebUI or the Admin CLI.
l Read-only access read-only: provides users of this group with read-only access to
the WebUI and Admin CLI.
The default is Full access full.
n Shell access
Shell access is not available if the Allow shell parameter has been disabled. See Disable
shell access for more information about the Allow shell parameter.
n Serial access
6. (Optional) Configure the serial ports to which users of this group have access:
a. Click Serial ports to expand the Serial ports node.
b. For Add Port, click .
To Next Page
Loading...
Need help?
General