Interfaces Wide Area Networks (WANs)
Digi Connect IT® 16/48 User Guide
67
(config network interface my_wan ipv4 surelink target 0)>
interface_down_time value
(config network interface my_wan ipv4 surelink target 0)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes
the format number{w|d|h|m|s}.
For example, to set interface_down_time to ten minutes, enter either 10m or
600s:
(config network interface my_wan ipv4 surelink target 0)>
interface_down_time 600s
(config network interface my_wan ipv4 surelink target 0)>
The default is 60 seconds.
l (Optional) Set the amount of time to wait for an initial connection to the interface
before this test is considered to have failed:
(config network interface my_wan ipv4 surelink target 0)>
interface_timeout value
(config network interface my_wan ipv4 surelink target 0)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes
the format number{w|d|h|m|s}.
For example, to set interface_timeout to ten minutes, enter either 10m or 600s:
(config network interface my_wan ipv4 surelink target 0)>
interface_timeout 600s
(config network interface my_wan ipv4 surelink target 0)>
The default is 60 seconds.
(Optional) Repeat to add additional test targets.
8. Optional active recovery configuration parameters:
a. Move back two levels in the configuration by typing .. ..:
(config network interface my_wan ipv4 surelink target 0)> .. ..
(config network interface my_wan ipv4 surelink>
b. Set the Interval between connectivity tests:
(config network interface my_wan ipv4 surelink)> interval value
(config network interface my_wan ipv4 surelink>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set interval to ten minutes, enter either 10m or 600s:
(config network interface my_wan ipv4 surelink)> interval 600s
(config network interface my_wan ipv4 surelink)>
The default is 15 minutes.
To Next Page
Loading...
Need help?
General