Digi Connect IT 16 User Manual

Diagnostics Configure options for the event and system logs
Digi Connect IT® 16/48 User Guide
672
ii. To disable informational messages for the DHCP server:
(config)> system log event dhcpserver info false
(config)>
iii. To change the status interval:
(config)> system log event dhcpserver status_interval value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set the status interval to ten minutes, enter either 10m or 600s:
(config)> system log event dhcpserver status_interval 600s
(config)>
6. (Optional) See Configure syslog servers for information about configuring remote syslog
servers to which log messages will be sent.
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English