Interfaces Wide Area Networks (WANs)
IX30 User Guide
100
3. Configure active recovery on ETH1:
a. Click Network > Interface > ETH1 > IPv4 > SureLink.
b. For Interval, type 10s.
c. Click to expand Test targets.
d. Delete the existing test targets:
Click the menu icon (...) next to each target and select Delete.
e. For Add Test Target, click .
f. For Test type, select Ping test.
g. For Ping host, type 43.66.93.111.
h. For Ping payload size, type 256.
4. Repeat the above step for Modem to enable SureLink on that interface.
To Next Page
Loading...
