Services Location information
IX30 User Guide
532
Configure the location service
The location service is enabled by default. You can disable it, or you can enable it if it has been
disabled.
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location.
4. The location service is enabled by default. To disable, toggle off Enable.
5. For Location update interval, type the amount of time to wait between polling location
sources for new location data. The default is ten seconds.
To Next Page
Loading...
Need help?
General
