Services Network Time Protocol
IX30 User Guide
589
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to include additional firewall zones.
Note By default, the access control list for the NTP service is empty, which means that all
downstream hosts connected to the IX30 device can use the NTP service.
7. (Optional) Set the timezone for the location of your IX30 device. The default is UTC.
(config)> system time timezone value
(config)>
Where value is the timezone using the format specified with the following command:
(config)> system time timezone ?
Timezone: The timezone for the location of this device. This is used to
adjust the time for log
messages. It also affects actions that occur at a specific time of day.
Format:
Africa/Abidjan
Africa/Accra
Africa/Addis_Ababa
...
(config)>
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show status and statistics of the NTP server
You can display status and statistics for active NTP servers
Web
To Next Page
Loading...
Need help?
General
