Digi IX30

Routing Show the routing table
IX30 User Guide
304
----------
bgp BGP
isis IS-IS
nhrp NHRP
ospfv2 OSPFv2
ospfv3 OSPFv3
rip RIP
ripng RIPng
(config)>
b. Enable a routing service that will be used. For example, to enable the RIP service:
(config)> network route service rip enable true
(config)>
c. Complete the configuration of the routing service. For example, use the ? to view the
available parameters for the RIPservice:
(config)> network route service rip ?
Parameters Current Value
---------------------------------------------------------------------
----------
ecmp false Allow ECMP
enable true Enable
Additional Configuration
---------------------------------------------------------------------
----------
interface Interfaces
neighbour Neighbours
redis Route redistribution
timer Timers
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show the routing table
To display the routing table:
Web