Digi IX30 User Manual

Diagnostics Configure options for the event and system logs
IX30 User Guide
928
b. Enable the server:
(config system log remote 0)> enable true
(config system log remote 0)>
c. Set the host name or IP address of the server:
(config system log remote 0)> server hostname
(config system log remote 0)>
d. The event categories that will be sent to the server are automatically enabled when the
server is enabled.
n
To disable informational event messages:
(config system log remote 0)> info false
(config system log remote 0)>
n
To disable status event messages:
(config system log remote 0)> status false
(config system log remote 0)>
n
To disable informational event messages:
(config system log remote 0)> error false
(config system log remote 0)>
4. Set the port number to use for the syslog server:
(config system log remote 0)> port value
(config system log remote 0)>
where value is any integer between 1 and 65535. The default is 514.
5. Set the IP protocol to use for communication with the syslog server:
(config system log remote 0)> protocol value
(config system log remote 0)>
where value is either tcp or udp. The default is udp.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure options for the event and system logs
The default configuration for event and system logging is:

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM