Serial port Electrical Signalling Mode
IX30 User Guide
260
Change the electrical signalling mode to RS-232
Note The default setting for the IX30's signalling mode is RS-232. This procedure is only necessary if
the mode has been previously changed.
To change the signalling mode:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Serial > Port 1.
To Next Page
Loading...
