Applications Set up the IX30 to automatically run your applications
IX30 User Guide
679
If once is enabled, rebooting the device will cause the script to run again. The only way to re-
run the script is to:
n
Remove the script from the device and add it again.
n
Make a change to the script.
n
Disable once.
10. Sandbox is enabled by default. This option protects the script from accidentally destroying the
system it is running on.
(config system schedule script 0)> sandbox true
(config system schedule script 0)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show script information
You can view status and statistics about location information from either the WebUI or the command
line.
Web
1. Log into the IX30 WebUI as a user with Admin access.
2. At the Status page, click Scripts.
The Scripts page displays:
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.