Services Use the iPerf service
IX30 User Guide
613
Totals
------
Bytes sent : 158400
Bytes received : 4500
Messages sent : 0
Messages received : 0
Clients
-------
Total : 1
Maximum : 5
Connected : 1
Disconnected : 0
Expired : 0
Subscriptions
-------------
Total : 1
Shared : 1
Message Store
-------------
Bytes : 151
Messages : 35
Retained messages : 40
PUBLISH Messages
----------------
Bytes sent : 0
Bytes received : 0
Messages sent : 0
Messages received : 0
Messages dropped : 0
>
3. Use the show mqtt command to return additional information, including averages over one,
five, and fifteen minutes.
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Use the iPerf service
Your IX30 device includes an iPerf3 server that you can use to test the performance of your network.
iPerf3 is a command-line tool that measures the maximum network throughput an interface can
handle. This is useful when diagnosing network speed issues, to determine, for example, whether a
cellular connection is providing expected throughput.
The IX30 implementation of iPerf3 supports testing with both TCP and UDP.