Digi IX30

Services Use the iPerf service
IX30 User Guide
614
Note Using iPerf clients that are at a version earlier than iPerf3 to connect to the IX30 device's iPerf3
server may result in unpredictable results. As a result, Digi recommends using an iPerf client at
version 3 or newer to connect to the IX30 device's iPerf3 server.
Required configuration items
n
Enable the iPerf server on the IX30 device.
n
An iPerf3 client installed on a remote host. iPerf3 software can be downloaded at
https://iperf.fr/iperf-download.php.
Additional configuration Items
n
The port that the IX30 device's iPerf server will use to listen for incoming connections.
n
The access control list for the iPerf server.
When the iPerf server is enabled, the IX30 device will automatically configure its firewall rules
to allow incoming connections on the configured listening port. You can restrict access by
configuring the access control list for the iPerf server.
To enable the iPerf3 server:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.