Digi IX30 User Manual

Interfaces Local Area Networks (LANs)
IX30 User Guide
150
Local Area Networks (LANs)
The IX30 device is preconfigured with the following Local Area Networks (LANs):
Interface
type Preconfigured interfaces Devices Default configuration
Local Area
Network
(LAN)
n
ETH2
n
Ethernet:
ETH2
n
Firewall zone:
Internal
n
IP address:
192.168.2.1/24
n
DHCP server
enabled
n
LAN priority:
Metric=5
n
Loopback
n
Ethernet:
Loopback
n
Firewall zone:
Loopback
n
IP address:
127.0.0.1/8
n
Default IP
n
Ethernet:
ETH2
n
Firewall zone: Setup
n
IP address
192.168.210.1/24
n
Default Link-local IP
n
Ethernet:
ETH2
n
Firewall zone: Setup
n
IP address
169.254.100.100/16
You can modify configuration settings for ETH2, and you can create new LANs.
This section contains the following topics:
About Local Area Networks (LANs) 151
Configure a Local Area Network (LAN) 151
Configure the WAN/ETH1 port as a LAN or in a bridge 158
Change the default LAN subnet 166
Show LAN status and statistics 168
Delete a LAN 169
DHCP servers 171
Default services listening on LANports 188
Configure an interface to operate in passthrough mode. 188

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM