Digi IX30 User Manual

Interfaces Local Area Networks (LANs)
IX30 User Guide
166
d. Set the device to the new bridge:
(config network interface LAN_bridge_interface)> device
/network/bridge/LAN_bridge
(config network interface LAN_bridge_interface)>
e. Set the IPv4 address and netmask for the interface, using the format IPv4_
address/netmask, for example, 192.168.3.1/24:
(config network interface LAN_bridge_interface)> ipv4 address
192.168.3.1/24
(config network interface LAN_bridge_interface)>
f. Enable the DHCP server:
(config network interface LAN_bridge_interface)> ipv4 dhcp_server
enable true
(config network interface LAN_bridge_interface)>
5. Disable the eth1 interface:
(config)> network interface eth1 enable false
(config)>
6. Save the configuration and apply the change:
(config network interface LAN_bridge_interface)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Change the default LAN subnet
You can change the IX30 default LAN subnet—192.168.2.1/24—to any range of private IPs. The local
DHCP server range will also change to the range of the LAN subnet.
To change the LAN subnet:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM