User authentication LDAP
IX30 User Guide
736
LDAP
Your IX30 device supports LDAP (Lightweight Directory Access Protocol), a protocol used for directory
information services over an IP network. LDAP can be used with your IX30 device for centralized
authentication and authorization management for users who connect to the device. With LDAP
support, the IX30 device acts as an LDAP client, which sends user credentials and connection
parameters to an LDAP server. The LDAP server then authenticates the LDAP client requests and sends
back a response message to the device.
When you are using LDAP authentication, you can have both local users and LDAP users able to log in
to the device. To use LDAP authentication, you must set up a LDAP server that is accessible by the
IX30 device prior to configuration. The process of setting up a LDAP server varies by the server
environment.
This section contains the following topics:
LDAP user configuration 737
LDAP server failover and fallback to local configuration 738
Configure your IX30 device to use an LDAP server 738
To Next Page
Loading...
Need help?
General
