Digi IX30 User Manual

Interfaces Wide Area Networks (WANs)
IX30 User Guide
110
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> network interface modem modem apn 0 apn value
(config)>
where value is the APN for the SIM card.
4. (Optional) To add additional APNs:
a. Use the add command to add a new APN entry. For example:
(config)> add network interface modem modem apn end
(config network interface modem modem apn 1)>
b. Set the value of the APN:
(config network interface modem modem apn 1)> apn value
(config network interface modem modem apn 1)>
where value is the APN for the SIM card.
5. (Optional) Set the IP version:
(config)> network interface modem modem apn 0 ip_version version
(config)>
where version is one of the following:
n
auto: Requests both IPv4 and IPv6 address.
n
ipv4: Requests only an IPv4 address.
n
ipv6: Requests only an IPv6 address.
The default is auto.
6. (Optional) Set the authentication method:
(config)> network interface modem modem apn 0 auth method
(config)>
where method is one of the following:
n
none: No authentication is required.
n
auto: The device will attempt to connect using CHAP first, and then PAP.
n
chap: Uses the Challenge Handshake Authentication Profile (CHAP) to authenticate.
n
pap: Uses the Password Authentication Profile (PAP) to authenticate.
If auto, chap, or pap is selected, enter the Username and Password required to authenticate:
(config)> network interface modem modem apn 0 username name
(config)> network interface modem modem apn 0 password pwd
(config)>
The default is none.

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM