Digi IX30 User Manual

Interfaces Wide Area Networks (WANs)
IX30 User Guide
118
g. Add a new routing policy:
(config network route policy )> add end
(config network route policy 1)>
h. Set the label that will be used to identify this route policy:
(config network route policy 1)> label "Route through private apn"
(config network route policy 1)>
i. Set the interface:
(config network route policy 1)> interface
/network/interface/WWANPrivate
(config network route policy 1)>
j. Configure the source address:
i. Set the source type to interface:
(config network route policy 1)> src type interface
(config network route policy 1)>
ii. Set the interface to LAN2:
(config network route policy 1)> src interface LAN2
(config network route policy 1)>
k. Configure the destination address:
i. Set the type to interface:
(config network route policy 1)> dst type interface
(config network route policy 1)>
ii. Set the interface to WWANPrivate :
(config network route policy 1)> interface
/network/interface/WWANPrivate
(config network route policy 1)>
6. Save the configuration and apply the change:
(config network route policy 1)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure manual carrier selection
By default, your IX30 automatically selects the most appropriate cellular carrier based on the SIMthat
is in use and the status of available carriers in your area.

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM