Digi IX30

Interfaces Wide Area Networks (WANs)
IX30 User Guide
137
4. Create the WWAN or select an existing WWAN:
n
To create a new WWAN:
a. For Add interface, type a name for the WWAN and click .
b. For Interface type, select Modem.
New WWANs are enabled by default. To disable, toggle off Enable.
n
To edit an existing WWAN, click to expand the WWAN.
5. For Zone, select External.
6. For Device, select the cellular modem.
7. For Match SIMby, select a SIM matching criteria to determine when this WWAN should be
used:
n
If SIMslot is selected, for Match SIMslot, select which SIM slot must be in active for
this WWAN to be used.
n
If Carrier is selected, for Match SIMcarrier, select which cellular carrier must be in
active for this WWAN to be used.
n
If PLMN identifier is selected, for Match PLMN identifier, type the PLMN id that must
be in active for this WWAN to be used.
n
If IMSI is selected, for Match IMSI, type the International Mobile Subscriber Identity
(IMSI) that must be in active for this WWAN to be used.
n
If ICCID is selected, for Match ICCID, type the unique SIMcard ICCIDthat must be in
active for this WWAN to be used.
8. Type the PIN for the SIM. Leave blank if no PIN is required.
9. Type the Phone number for the SIM, for SMS connections.
Normally, this should be left blank. It is only necessary to complete this field if the SIM does
not have a phone number or if the phone number is incorrect.
10. Roaming is enabled by default. Click to disable.