Digi IX30 User Manual

Interfaces Local Area Networks (LANs)
IX30 User Guide
194
where value is one of:
n
always: DNS will always be used for this WAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
n
primary: Only use the DNS servers provided for this interface when the interface is
the primary route.
n
never: Never use DNS servers for this interface.
f. See Configure SureLink active recovery to detect WAN/WWAN failures for information
about configuring SureLink for active recovery.
9. (Optional) Configure IPv6 settings:
a. Enable IPv6 support:
(config network interface ip_passthrough_interface)> ipv6 enable true
(config network interface ip_passthrough_interface)>
b. Generally, the default settings for IPv6 support are sufficient. You can view the default IPv6
settings by using the question mark (?):
(config network interface ip_passthrough_interface)> ipv6 ?
IPv6
Parameters Current Value
----------------------------------------------------------------------
---------
enable true Enable
metric 0 Metric
mgmt 0 Management priority
mtu 1500 MTU
use_dns always Use DNS
weight 10 Weight
(config network interface ip_passthrough_interface)>
c. Modify any of the remaining default settings as appropriate.
10. (Optional) To configure 802.1x port based network access control:
Note The IX30 can function as an 802.1x authenticator; it does not function as an 802.1x
supplicant.
a. Enable the 802.1x authenticator on the IX30 device:
(config network interface ip_passthrough_interface)> 802_1x
authentication enable true
(config network interface ip_passthrough_interface)>

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM