Digi IX30 User Manual

Routing IP routing
IX30 User Guide
278
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a new static route:
(config)> add network route static end
(config network route static 0)>
New static route instances are enabled by default. To disable:
(config network route static 0)> enable false
(config network route static 0)>
4. (Optional) set a label that will be used to identify this route. For example:
(config network route static 0)> label "route to accounting network"
(config network route static 0)>
5. Set the IP address or network of the destination of this route. For example:
(config network route static 0)> destination ip_address[/netmask]
(config network route static 0)>
For example, to route traffic to the 192.168.47.0 network that uses a subnet mask of
255.255.255.0:
(config network route static 0)> dst 192.168.47.0/24
(config network route static 0)>
The any keyword can also be used to route packets to any destination with this static route.
6. Set the interface on the IX30 device that will be used with this static route:
a. Use the ? to determine available interfaces:
(config network route static 0)> interface ?
Interface: The network interface to use to reach the destination.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config network route static 0)> interface

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM