Routing IP routing
IX30 User Guide
293
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Routes > Policy-based routing.
4. Click the to add a new route policy.
5. For Label, type Domain-based policy.
6. For Interface, select ETH1.
7. Configure the source address:
a. Click to expand Source address.
b. For Type, select Zone.
c. For Zone, select Any.
8. Configure the destination address:
a. Click to expand Destination address.
b. For Type, select Domain.
c. Click to expand Domains.
d. Click the to add a new domain.