Digi IX30 User Manual

Routing IP routing
IX30 User Guide
298
6. Create a packet filtering rule that rejects all other LAN packets on the cellular WANinterface.
a. Click Firewall > Packet filtering.
b. Click the  to add a new packet filtering rule.
c. For Label, type Reject LAN traffic to cellular WAN.
d. For Action, select Drop.
e. For Source zone, select Internal.
f. For Destination zone, select CellularWAN.
7. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM