Digi IX30 User Manual

Routing IP routing
IX30 User Guide
300
b. Set the label that will be used to identify this route policy:
(config network route policy 0)> label "VoIP phone"
(config network route policy 0)>
c. Set the interface:
(config network route policy 0)> interface /network/interface/
(config network route policy 0)>
d. Configure the source as the MAC address of the VoIP phone:
i. Set the source type to mac:
(config network route policy 0)> src type mac
(config network route policy 0)>
ii. Set the MACaddress to the MAC address of the VoIP phone:
(config network route policy 0)> src mac 26:88:0E:23:50:C2
(config network route policy 0)>
e. Configure the destination zone:
i. Set the source destination to zone:
(config network route policy 0)> dst type zone
(config network route policy 0)>
ii. Set the zone to CellularWAN:
(config network route policy 0)> dst zone CellularWAN
(config network route policy 0)>
6. Create a packet filtering rule that rejects all other LAN packets on the cellular WANinterface:
a. Create a new packet filtering rule:
i. Type ... to move to the root of the configuration:
(config network route policy 0)> ...
(config)>
ii. Create the packet filtering rule:
(config)> add firewall filter end
(config firewall filter 2)>
b. Set the lable to Reject LAN traffic to cellular WAN:
(config firewall filter 2)> label "Reject LAN traffic to cellular WAN"
(config firewall filter 2)>

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM