Routing Virtual Router Redundancy Protocol (VRRP)
IX30 User Guide
319
i. Click to expand IPv4 > SureLink.
ii. Click Enable.
iii. For Interval, type a the amount of time to wait between connectivity tests. To
guarantee seamless internet access for VRRP+ purposes, SureLink tests should occur
more often than the default of 15 minutes.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take
the format number{w|d|h|m|s}. For example, to set Interval to five seconds, enter 5s.
iv. Click to expand Test targets > Test target.
v. Configure the test target. For example, to configure SureLink to verify internet
connectivity on the LAN by pinging my.devicecloud.com:
i. For Test Type, select Ping test.
ii. For Ping host, type my.devicecloud.com.
11. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new VRRP instance, or edit an existing one. See Configure VRRP for information about
creating a new VRRP instance.
4. Enable VRRP+:
(config)> network vrrp VRRP_test vrrp_plus enable true
(config)>
To Next Page
Loading...
Need help?
General
