Routing Virtual Router Redundancy Protocol (VRRP)
IX30 User Guide
335
3. Click Status > VRRP.
The Virtual Router Redundancy Protocol window is displayed.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type show vrrp:
> show vrrp
VRRP Status Proto State Virtual IP
---- ------ ----- ------ -------------
VRRP_test Up IPv4 Backup 10.10.10.1
VRRP_test Up IPv4 Backup 100.100.100.1
>
3. To display additional information about a specific VRRP instance, at the Admin CLI prompt,
type show vrrp name name:
> show vrrp name VRRP_test
VRRP_test VRRP Status
---------------------
Enabled : True
Status : Up
Interface : lan
To Next Page
Loading...
