Digi IX30

Virtual Private Networks (VPN) L2TP
IX30 User Guide
462
(config vpn l2tp lac lac_tunnel)> surelink success_condition value
(config vpn l2tp lac lac_tunnel)>
Where value is either one or all.
9. Set the number of probe attempts before the WAN is considered to have failed:
(config vpn l2tp lac lac_tunnel)> surelink attempts num
(config vpn l2tp lac lac_tunnel)>
The default is 3.
10. Set the amount of time that the device should wait for a response to a probe attempt before
considering it to have failed:
(config vpn l2tp lac lac_tunnel)> surelink timeout value
(config vpn l2tp lac lac_tunnel)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set interval to ten minutes, enter either 10m or 600s:
(config vpn l2tp lac lac_tunnel)> surelink timeout 600s
(config vpn l2tp lac lac_tunnel)>
The default is 15 seconds.
11. Configure test targets:
a. Add a test target:
(config vpn l2tp lac lac_tunnel)> add surelink target end
(config vpn l2tp lac lac_tunnel surelink target 0)>
b. Set the test type:
(config vpn l2tp lac lac_tunnel surelink target 0)> test value
(config vpn l2tp lac lac_tunnel surelink target 0)>
where value is one of:
n
ping: Tests connectivity by sending an ICMP echo request to a specified hostname
or IP address.
l
Specify the hostname or IP address:
(config vpn l2tp lac lac_tunnel surelink target 0)> ping_host
host
(config vpn l2tp lac lac_tunnel surelink target 0)>
l
(Optional) Set the size, in bytes, of the ping packet:
(config vpn l2tp lac lac_tunnel surelink target 0)> ping_size
[num]
(config vpn l2tp lac lac_tunnel surelink target 0)>