Digi IX30 User Manual

Virtual Private Networks (VPN) NEMO
IX30 User Guide
478
(config vpn nemo nemo_example)> coaddress address IP_address
(config vpn nemo nemo_example)>
The default is defaultroute.
12. Set the GREtunnel local endpoint:
a. Set the method to determine the GREtunnel local endpoint:
(config vpn nemo nemo_example)> tun_local type value
(config vpn nemo nemo_example)>
where value is one of:
n
defaultroute: Uses the same network interface as the default route.
n
interface
If interface is used, set the interface.
i. Use the ? to determine available interfaces:
(config vpn nemo nemo_example)> tun_local interface ?
Interface: The network interface to use to communicate with
the peer. Set this field to blank if using the default route.
Format:
defaultip
defaultlinklocal
eth1
eth2
loopback
Current value:
(config vpn nemo nemo_example)> tun_local interface
ii. Set the interface. For example:
(config vpn nemo nemo_example)> tun_local interface eth1
(config vpn nemo nemo_example)>
The default is defaultroute.
13. Configure one or more local networks to use as a virtual NEMO network interface. Generally,
this will be a Local Area Network (LAN):
a. Add a local network to use as a virtual NEMO network interface:
(config vpn nemo nemo_example)> add network end eth2
(config vpn nemo nemo_example)>
b. (Optional) Repeat for additional interfaces.
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM