Digi IX30

Firmware configuration Use the local RESTAPI to configure the IX30 device
IX30 User Guide
48
where path is the path to the list item, including the list number, in dot notation (for example,
service.ssh.acl.zone.4).
For example, to remove the external firewall zone to the ssh service:
1. Use the GETmethod to determine the SSHservice's list number for the external zone:
$ curl -k -u admin "https://192.168.210.1/cgi-
bin/config.cgi/value?path=service/ssh/acl/zone -X GET
{
"ok": true,
"result": {
"type": "array",
"path": "service.ssh.acl.zone"
, "collapsed": {
"0": "internal"
,
"1": "edge"
,
"2": "ipsec"
,
"3": "setup"
,
"4": "external"
}
}
}
$
2. Use the DELETE method to remove the external zone (list item 4).
$ curl -k -u admin https://192.168.210.1/cgi-
bin/config.cgi/value?path=service.ssh.acl.zone.4 -X DELETE
Enter host password for user 'admin':
{ "ok": true }
$