Digi IX30 User Manual

Services Configure SSHaccess
IX30 User Guide
502
n
To enable the mDNS protocol:
(config)> service ssh mdns enable true
(config>
n
To disable the mDNS protocl:
(config)> service ssh mdns enable false
(config)>
6. (Optional) Set the port number for this service.
The default setting of 22 normally should not be changed.
(config)> service ssh port 24
(config)>
7. To create custom SSHconfiguration settings:
a. Enable custom configurations:
(config)> service ssh custom enable true
(config)>
b. To override the standard SSHconfiguration and only use the config_file parameter:
(config)> service ssh custom override true
(config)>
n
If override is set to true, entries in Configuration file will be used in place of the
standard SSHconfiguration.
n
If override is set to false, entries in Configuration file will be added to the
standard SSHconfiguration.
The default is false.
c. Set the configuration settings:
(config)> service ssh custom config_file value
(config)>
where value is one or more entires in the form of an OpenSSH sshd_config file. For
example, to enable the diffie-helman-group-sha-14 key exchange algorithm:
(config)> service ssh custom config_file "KexAlgorithms +diffie-
hellman-group14-sha1"
(config)>
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM