Services Configure telnet access
IX30 User Guide
511
Where value can be:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the telnet service.
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX30 device:
(config)> add service telnet acl interface end value
(config)>
Where value is an interface defined on your device.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip Default IP
defaultlinklocal Default Link-local IP
eth1 ETH1
eth2 ETH2
loopback Loopback
modem Modem
(config)>
Repeat this step to list additional interfaces.
n
To limit access based on firewall zones:
(config)> add service telnet acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
To Next Page
Loading...
Need help?
General
