Digi IX30 User Manual

Services Simple Network Management Protocol (SNMP)
IX30 User Guide
528
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to include additional firewall zones.
5. Set the name of the user that will be used to connect to the SNMP agent.
(config)> service snmp username name
(config)>
6. Set the password for the user that will be used to connect to the SNMP agent:
(config)> service snmp password pwd
(config)>
7. (Optional) Set the port number for the SNMP agent. The default is 161.
(config)> service snmp port port
(config)>
8. (Optional) Configure Multicast DNS (mDNS)
mDNS is a protocol that resolves host names in small networks that do not have a DNS server.
For the SNMP agent, mDNS is disabled by default. To enable:
(config)> service snmp mdns enable true
(config>
9. (Optional) Set the authentication type. Allowed values are MD5 or SHA. The default is MD5.
(config)> service snmp auth_type SHA
(config)>
10. (Optional) Set the privacy passphrase. If not set, the password, entered above, is used.
(config)> service snmp privacy pwd
(config)>
11. (Optional) Set the privacy protocol, either DES or AES. The default is DES.

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM