Digi IX30 User Manual

Services Location information
IX30 User Guide
535
3. Click Services > Location > Location sources.
4. Click  to add a location source.
5. (Optional) Type a Label for this location source.
6. For Type of location source, select User-defined location.
7. The location source is enabled by default. Click Enable the location source to disable the
location source, or to enable it if it has been disabled.
8. For Latitude, type the latitude of the device. Allowed values are -90 and 90, with up to six
decimal places.
9. For Longitude, type the longitude of the device. Allowed values are -180 and 180, with up to
six decimal places.
10. For Altitude, type the altitude of the device. Allowed values are an integer followed by m or
km, for example, 100m or 1km.
11. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a location source:
(config)> add service location source end
(config service location source 0)>
The location source is enabled by default. To disable:
(config service location source 0)> enable false
(config service location source 0)>
4. (Optional) Set a label for this location source:
(config service location source 0)> label "label"
(config)>

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM