Digi IX30 User Manual

Central management Configure your device for Digi Remote Manager support
IX30 User Guide
54
3. Click Central management.
The Central management configuration window is displayed.
Digi Remote Manager support is enabled by default. To disable, toggle off Enable central
management.
4. (Optional) For Service, select either Digi Remote Manager or Digi aView. The default is Digi
Remote Manager.
5. (Optional) For Management server, type the URL for the central management server.
The default varies depending on firmware versions:
n
Firmware version 22.2.9.x and newer, the default is the edp12.devicecloud.com. This
server is for device-connectivity only, and uses enhanced security through certificate-
based communication. See Digi Remote Manager support for further infomation.
n
Firmware prior to version 22.2.9.x, the default is the Digi Remote Manager server,
my.devicecloud.com.
6. (Optional) For Management port, type the destination port for the remotecloud services
connection. The default is 3199.
7. Firmware server should normally be left at the default location.
8. (Optional) For Speedtest server, type the name or IP address of the server to use to test the
speed of the device's internet connection(s).
9. (Optional) For Retry interval, type the amount of time that the IX30 device should wait before
reattempting to connect to remotecloud services after being disconnected. The default is 30
seconds.
Allowed values are any number of hours, minutes, or seconds, and take the format number
{h|m|s}.
For example, to set Retry interval to ten minutes, enter 10m or 600s.
10. (Optional) For Keep-alive interval, type the amount of time that the IX30 device should wait
between sending keep-alive messages to remotecloud services when using a non-cellular
interface. The default is 60 seconds.
Allowed values are any number of hours, minutes, or seconds, and take the format number
{h|m|s}.
For example, to set Keep-alive interval to ten minutes, enter 10m or 600s.
11. (Optional) For Cellular keep-alive interval, type the amount of time that the IX30 device
should wait between sending keep-alive messages to remotecloud services when using a

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM