Digi IX30 User Manual

Containers Configure a container
IX30 User Guide
813
b. Set the network bridge device that will be used to provide network access:
i. Use the ? to determine the available bridges:
(config system container name)> bridge ?
Network Bridge Device: Containers require a bridge to access the
network. Choose
which bridge to connect the container to.
Format:
hotspot_bridge
lan1
Current value:
(config system container name)>
ii. Set the bridge:
(config system container name)> bridge lan1
(config system container name)>
c. (Optional) Set the IP address and netmask for the container:
(config system container name)> address IP_address/netmask
(config system container name)>
d. (Optional) Set the IP address of the network gateway:
(config system container name)> gateway IP_address
(config system container name)>
7. (Optional) Assign serial ports that the container will have access to:
a. Determine available serial ports:
(config system container name)> ... serial
Serial
Additional Configuration
---------------------------------------------------------------------
----------
port1 Port 1
...
(config system container name)>
b. Add the port:
(config system container name)> add ports end port1
(config system container name)>

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM