Digi IX30 User Manual

Monitoring intelliFlow
IX30 User Guide
895
11. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a group:
(config)> add monitoring intelliflow groups end
(config monitoring intelliflow groups 1)>
4. Set the domain name:
(config monitoring intelliflow groups 1)> domian digi.com
(config monitoring intelliflow groups 1)>
5. Set the group name:
(config monitoring intelliflow groups 1)> group Digi
(config monitoring intelliflow groups 1)>
6. Add another port:
(config monitoring intelliflow groups 1)> add .. end
(config monitoring intelliflow groups 2)>
7. Set the port number:
(config monitoring intelliflow groups 2)> domain devicecloud.com
(config monitoring intelliflow groups 2)>
8. Set the service type:
(config monitoring intelliflow groups 2)> group Digi
(config monitoring intelliflow groups 2)>
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM