Digi IX30 User Manual

Interfaces Wide Area Networks (WANs)
IX30 User Guide
98
8. Click the menu icon (...) next to the target and select Delete.
9. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change to WAN or WWAN's node in the configuration schema. For example, to disable SureLink
for an interface named my_wan:
(config)> network interface my_wan
(config network interface my_wan)>
4. Determine the index number of the target:
(config network interface my_wan)> show ipv4 surelink target
0
interface_down_time 600s
interface_timeout 120s
test interface_up
1
test dns_configured
(config network interface my_wan)>
5. Delete the target:
(config network interface my_wan> del ipv4 surelink target 1
(config network interface my_wan)>
6. Save the configuration and apply the change:
(config network interface my_wan ipv4 surelink)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM