Digi IX30 User Manual

Command line interface Configuration mode
IX30 User Guide
997
(config)> save
Configuration saved.
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Revert a subset of configuration changes to the default settings
There are two methods to revert a subset of configuration changes to the default settings.
n
Enter the revert command with the path parameter. For example, to revert all changes to the
authentication methods configuration:
1. Enter the revert command with the path set to auth method:
(config)> revert auth method
(config)>
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access
selection menu. Type quit to disconnect from the device.
n
Move to the location in the configuration and enter the revert command without the path
parameter. For example:
1. Change to the auth method node:
(config)> auth method
(config auth method)>
2. Enter the revert command:
(config auth method)> revert
(config auth method)>
3. Save the configuration and apply the change:
(config auth method)> save
Configuration saved.
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access
selection menu. Type quit to disconnect from the device.

Digi IX30 Specifications

General

Category	Network Router
Model	IX30
Serial Ports	1 x RS-232
Operating Temperature	-40° C to 70° C
Connectivity	Ethernet
USB Ports	1 x USB 2.0
Cellular Interface	4G LTE Cat 4
Wi-Fi	802.11 a/b/g/n/ac
SIM Slots	1
Processor	ARM Cortex-A9
Memory	1 GB RAM