Chapter 4 HYBRID Coater Service Manual ver1.1
36
overdrive function in the software which can ensure that a product definitely reaches the
stopper pins. When speed is high and/or weight of the product is high, it may be
necessary that the product is stopped earlier and therefore the product detect sensor can
be moved further away from the stopper pins.
F When the product detect sensor doesn’t recognize the product, it can be adjusted in
height by moving the sensor up or in an angle. With dull surfaces at the underside of the
product it can be useful to set the product detect sensor in angle.
G When the product detect sensor doesn’t recognize the product, it also possible to adjust
the illumination by turning the adjusting screw (#10).
10
To Next Page
Loading...
