DIMA HC-200 - User Manual

TB-1026
HybridC
HC-100/200
Service Manual Ver1.1
This document contains proprietary information which is protected by copyright. All rights are
reserved. No parts of this document may be photocopied, reproduced, or translated into
another language without the prior written consent of DIMA Group B.V. .
The information contained in this document is subject to change without prior notice.
© Copyright 2008 DIMA Group B.V.

Summary

Safety Precautions for HYBRID Coater

General Safety Warnings

Lists critical safety precautions and warnings for operating the HYBRID C machine.

Emergency Switches

Details the location and function of emergency stop switches on the machine.

Machine Installation Procedures

Pre-installation Checks

Lists requirements and checks before installing the machine.

Unpacking and Removing Transport Locks

Provides steps for safely unpacking the machine and removing transport locks.

Placing and Leveling the Machine

Details procedures for correctly placing and leveling the machine.

Connections and Pressure Setting

Guides on connecting power, PC, and setting air pressure.

Completion of the Installation

Steps to finalize machine installation, including calibration and testing.

Maintenance Procedures for HYBRID C

Maintenance Introduction

Introduces regular maintenance tasks for optimal machine condition.

Service Diagnostics

Explains how to use diagnostics for performance checks and maintenance scheduling.

Regular Maintenance Schedule

Outlines a regular maintenance schedule and checklist for service engineers.

Maintenance Checklist

Provides a checklist for semi-annual maintenance tasks.

Small Repairs and Adjustments

Replacing Stepper Motors

General procedure for replacing stepper motors on HC-100 and HC-200.

Replacing X and Y Axis Stepper Motors

Detailed steps for replacing X and Y axis stepper motors.

Replacing Z Axis Stepper Motor (HC-200)

Instructions for replacing the Z-axis stepper motor on the HC-200.

Replacing Ø Axis Stepper Motor (HC-200)

Guide for replacing the Ø-axis stepper motor on the HC-200.

Replacing and Adjusting the Encoder

Procedure for replacing and adjusting the Ø-axis encoder on the HC-200.

Adjusting X, Y, Z, and Ø Movement Limits

Procedure for adjusting movement limits on X, Y, Z, and Ø axes.

Adjusting X Axis Limits

Steps to adjust the X-axis movement limits.

Adjusting Y Axis Limits

Steps to adjust the Y-axis movement limits.

Adjusting Z Axis Limits (HC-100)

Instructions for adjusting Z-axis limits on the HC-100.

Adjusting Z Axis Limits (HC-200)

Guide for adjusting Z-axis limits on the HC-200.

Adjusting Ø Axis Limits (HC-200)

Instructions for adjusting Ø-axis movement limits on the HC-200.

Appendix I: I;O Assignment

DIMA HC-200 Specifications

General

Brand	DIMA
Model	HC-200
Category	Dispenser
Language	English