HYBRID Coater Service Manual ver1.1 Chapter 1
5
1.2 Model Overview
The HYBRID C is available in two versions:
HC-100: The HC-100 robot is equipped with X, Y, and Z axis. The 3-axis robot can handle
up to 4 different tools. Tools can be dispense valves, spray valves, grippers, etc.
They are mounted onto a Z slide, or on a Z slide combined with a fixed tilt
mechanism as a fourth axis. This combination is mounted onto an adapter for 1, 2,
3, or 4 valves. Tools and valves can be configured outside of the machine and can
be mounted onto the robot as one single unit. The 3-axis robot comes with a
camera on the Z axis, computer with DIMASOFT User Software, a base for
adapter plates, one electronic pressure transducer for the main air supply, one
electronic pressure transducer for detection of exhausted air and illumination
inside the machine.
HC-200: The HC-200 robot is equipped with X, Y and Z and Φ axis. The 4-axis robot can
handle up to 4 different tools. Tools can be dispense valves, spray valves,
grippers, etc. They are mounted onto a valve mount. Tools and valves can be
configured outside of the machine and can be mounted onto the robot as one
single unit. The 4-axis robot comes with a camera on the Z axis, computer with
DIMASOFT User Software, a base for up to 4 valve mounts, one electronic
pressure transducer for the main air supply, one electronic pressure transducer for
detection of exhausted air and illumination inside the machine.
Both robots can be configured as a batch or inline machine and can be reconfigured in the
field at any time.
To Next Page
Loading...
