Chapter 2 HYBRID Coater Servicce Manual ver1.1
6
2. Safety
Refer to the User Manual for general Safety Information.
2.1 Warnings
Never enter the machine when the motors of the Coating
Head or of the Conveyor are running.
Do not overrule the hood locks and do not run the HYBRID
C in any way with the hoods open.
Do not overrule the push buttons place don the Safety
Panel.
When working with test fluids be aware of the following:
Consult the Material Safety Data Sheet (MSDS) for all fluids
used with the HYBRID C. The MSDS provides material
usage instructions, safety precautions, information about
personal protective equipment, and disposal instructions.
Fluids can be extremely dangerous when working with high
pressure. They should be safely contained. Be sure the
pressure is removed before performing any adjustments or
maintenance. A beam of high pressure fluid can cut like a
sharp knife and can even result in death.
2.2 Emergency Switches
Emergency switches are installed on two places on the machine. Immediately push one of
these switches when an emergency occurs. The machine will immediately switch off. The pC
and the motor stay on.
When the situation is normal again, the Emergency Switch can be pulled out and the
machine can be restarted as described in the User Manual.
To Next Page
Loading...