DIMA HC-200 - Default Chapter; Table of Contents

HYBRID Coater Service Manual ver?1.1 Table of Contents
1
Table of Contents
1. Introduction 4
1.1 About this Manual 4
1.2 Model Overview 5
2. Safety 6
2.1 Warnings 6
2.2 Emergency Switches 6
3. Machine Overview 7
3.1 Introduction 7
3.2 Electrical Block Diagram 7
3.3 Block Diagram of Air 8
3.3.1 Routing of the Air Lines 9
3.3.2 Air Lines Routing of the Options 10
3.3.2.1 With Options HC-1050 or HC-1051 10
3.3.2.2 With Options HC-1000, HC-1010, or HC-1030 12
3.4 With Options HC-1160/1170 14
3.5 Electrical Compartment in Front 15
3.6 Electrical Compartment in Rear 17
3.7 Detection of Exhausted Air 19
3.8 X and Y Movement 19
3.9 Head with Connection PCB 20
3.10 Dispense Head PCB 21
3.11 Z Movement at HC-100 21
3.12 ZØ Movement at HC-200 22
3.13 Embedded Software 23
3.14 Additional Revision Information 23
3.14.1 General 23
3.14.2 HC-100 Specific 24
3.14.3 HC-200 Specific 24
3.14.4 HC-1160/ HC-1170 General 24
3.14.5 HC-1170 Specific 24
4. Machine Installation 25
4.1 Pre-installation Checks 25
4.2 Unpacking the Machine and Removing Transport Locks 25
4.3 Placing and Leveling the Machine 27
4.4 Connections and Pressure Setting 27
4.5 Completion of the Installation 28
4.6 Installing Special Options 28
4.6.1 Installing Options DD-52XX 28
4.6.2 Installing Option HC-1050/ HC-1051 28
4.6.3 Installing Option HC-1210/ HC-1215 31
4.6.4 Installing Option HC-1230/ HC-1231 31
4.6.5 Installing Options HC-1235 and HC-1236 32
4.6.6 Installing Option HC-1320 32
4.7 Installing Options HC-1380 and HC-1390 34
4.8 Installing Options HC-1160 and HC-1170 35